This work is aimed at the valorization of the organic fraction of urban solid waste through the stabilization and the inertisation in thermoplastic and thermoset resins. After being ground, the organic waste was subjected to a stabilization process; different procedures were used in order to obtain a partial or complete removal of the bacterial activity. Afterwards, the inertisation process was carried out through the incorporation of the organic waste into water soluble thermoplastic and thermoset matrices. Samples produced were tested by using differential scanning calorimetry (DSC), and thermogravimetric analysis (TGA), in order to evaluate the water content of the mixture. The viscosity of the material was then assessed through rheological analysis, thus allowing to understand times and temperatures necessary for the polymerization, in case of the thermoset matrix, or for the evaporation of water, in case of the thermoplastic one. Flexural and compressive tests were carried out on samples obtained after inertisation. Results showed good values of flexural and compressive strength. Also, the influence of the residual water content on the mechanical properties was studied, and an increase of the compressive modulus with the increase of the water content was found. Finally, different amounts of foaming agents were added to the mixtures during the inertisation; compressive tests were then carried out to evaluate the influence of the voids on the mechanical properties.

Novel Organic waste based hybrid polymer materials

F. Ferrari;R. Striani;C. Esposito Corcione;P. Visconti;A. Greco
2018-01-01

Abstract

This work is aimed at the valorization of the organic fraction of urban solid waste through the stabilization and the inertisation in thermoplastic and thermoset resins. After being ground, the organic waste was subjected to a stabilization process; different procedures were used in order to obtain a partial or complete removal of the bacterial activity. Afterwards, the inertisation process was carried out through the incorporation of the organic waste into water soluble thermoplastic and thermoset matrices. Samples produced were tested by using differential scanning calorimetry (DSC), and thermogravimetric analysis (TGA), in order to evaluate the water content of the mixture. The viscosity of the material was then assessed through rheological analysis, thus allowing to understand times and temperatures necessary for the polymerization, in case of the thermoset matrix, or for the evaporation of water, in case of the thermoplastic one. Flexural and compressive tests were carried out on samples obtained after inertisation. Results showed good values of flexural and compressive strength. Also, the influence of the residual water content on the mechanical properties was studied, and an increase of the compressive modulus with the increase of the water content was found. Finally, different amounts of foaming agents were added to the mixtures during the inertisation; compressive tests were then carried out to evaluate the influence of the voids on the mechanical properties.
File in questo prodotto:
Non ci sono file associati a questo prodotto.

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11587/427219
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus ND
  • ???jsp.display-item.citation.isi??? ND
social impact