The flame stabilization represents a relevant issue in aero-engine design. In fact, the growing demand of pollutant emissions reduction without significant losses of the combustion efficiency has driven the efforts of the scientific community towards lean flames. Lean fuel mixtures, characterized by low temperature flames, could manifest an unstable behaviour which can easily lead to the flame extinction due to the establishment of the blowout condition. This requires the implementation of control systems to avoid flame instability occurrence. The present work shows an investigation of the impact of dielectric barrier discharge (DBD) plasma actuation on lifted flame stabilization in a methane CH4-air Bunsen burner at ambient conditions. Two different plasma actuator configurations, powered with a high voltage (HV)/high frequency sinusoidal signal, have been investigated. Once the best actuator configuration was selected, the efficiency of the plasma actuation has been evaluated in terms of the flame lift-off distance, length and shape. In particular, in order to change the actuator power dissipation, different peak-to-peak voltages Vpp were tested, while the actuation frequency was kept equal to 20 kHz. The application of plasma discharges to flame stabilization leads to plasma-attached flames or plasma-enhanced lifted flames, depending on the air and fuel flow rates. At air flow rate of 1.54 g/s, plasma actuation allowed to decrease the lift-off height until the fuel jet velocity was below about 0.05 m/s thanks to the extension of the flame region upstream, toward the burner exit section. Beyond this value, it had no significant impact on the flame lift-off height, even though the amplitude of the lift-off height oscillations reduced coupled with a more stable behaviour of the lifting flame. The benefit of the plasma actuation increased by reducing the air flow rate to 1.35 g/s. In this condition, plasma-assisted flame reattachment was evident at each fuel velocity, in combination with an increasing flame height proportionally to the fuel jet velocity.
Plasma actuation for lifted flame stabilization in coaxial methane-air flow
DE GIORGI M. G.;Antonio FICARELLA;Donato FONTANAROSA;Elisa PESCINI;Antonio SUMA
2019-01-01
Abstract
The flame stabilization represents a relevant issue in aero-engine design. In fact, the growing demand of pollutant emissions reduction without significant losses of the combustion efficiency has driven the efforts of the scientific community towards lean flames. Lean fuel mixtures, characterized by low temperature flames, could manifest an unstable behaviour which can easily lead to the flame extinction due to the establishment of the blowout condition. This requires the implementation of control systems to avoid flame instability occurrence. The present work shows an investigation of the impact of dielectric barrier discharge (DBD) plasma actuation on lifted flame stabilization in a methane CH4-air Bunsen burner at ambient conditions. Two different plasma actuator configurations, powered with a high voltage (HV)/high frequency sinusoidal signal, have been investigated. Once the best actuator configuration was selected, the efficiency of the plasma actuation has been evaluated in terms of the flame lift-off distance, length and shape. In particular, in order to change the actuator power dissipation, different peak-to-peak voltages Vpp were tested, while the actuation frequency was kept equal to 20 kHz. The application of plasma discharges to flame stabilization leads to plasma-attached flames or plasma-enhanced lifted flames, depending on the air and fuel flow rates. At air flow rate of 1.54 g/s, plasma actuation allowed to decrease the lift-off height until the fuel jet velocity was below about 0.05 m/s thanks to the extension of the flame region upstream, toward the burner exit section. Beyond this value, it had no significant impact on the flame lift-off height, even though the amplitude of the lift-off height oscillations reduced coupled with a more stable behaviour of the lifting flame. The benefit of the plasma actuation increased by reducing the air flow rate to 1.35 g/s. In this condition, plasma-assisted flame reattachment was evident at each fuel velocity, in combination with an increasing flame height proportionally to the fuel jet velocity.I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
