Epoxy-based composites are designed for long-lasting applications, though their wide use is in contrast with their poor recyclability, which poses serious end-of-life issues. In order to reduce their environmental impact, precursors derived from fossil fuel based raw materials should be replaced with eco-friendly sources. This can be attained by using naturally derived epoxy matrices, or by finding a suitable solution for recycling at the end of life. In this paper, both strategies were analyzed, by replacing traditional monomers with epoxidized waste flour (EWF), an innovative bio-precursor derived from the organic waste stream, and a cleavable hardener, which allowed the recyclability of the matrix. The recyclable matrix was reinforced with recycled carbon fibers, derived from pyrolysis. DSC measurements were carried out in order to optimize the curing steps of the matrix, then flexural tests were performed in order to evaluate the mechanical response of the composite. A green recycling procedure was then investigated, which involved the use of non-toxic solvents and mild working conditions, and allowed recovery of the matrix while still preserving the properties of the carbon fibers. The components obtained after recycling were analyzed by FTIR analysis, which revealed the presence of the epoxy ring on the recycled waste flour. Hence, recycled waste flour was again used as a precursor and mixed with the cleavable hardener, thus, obtaining a closed-loop recycling.

Innovative Closed-Loop Recyclable Bio-Based Composites from Epoxidized Waste Flour and Recycled Carbon Fibers

Ferrari F.;Greco A.
2022-01-01

Abstract

Epoxy-based composites are designed for long-lasting applications, though their wide use is in contrast with their poor recyclability, which poses serious end-of-life issues. In order to reduce their environmental impact, precursors derived from fossil fuel based raw materials should be replaced with eco-friendly sources. This can be attained by using naturally derived epoxy matrices, or by finding a suitable solution for recycling at the end of life. In this paper, both strategies were analyzed, by replacing traditional monomers with epoxidized waste flour (EWF), an innovative bio-precursor derived from the organic waste stream, and a cleavable hardener, which allowed the recyclability of the matrix. The recyclable matrix was reinforced with recycled carbon fibers, derived from pyrolysis. DSC measurements were carried out in order to optimize the curing steps of the matrix, then flexural tests were performed in order to evaluate the mechanical response of the composite. A green recycling procedure was then investigated, which involved the use of non-toxic solvents and mild working conditions, and allowed recovery of the matrix while still preserving the properties of the carbon fibers. The components obtained after recycling were analyzed by FTIR analysis, which revealed the presence of the epoxy ring on the recycled waste flour. Hence, recycled waste flour was again used as a precursor and mixed with the cleavable hardener, thus, obtaining a closed-loop recycling.
File in questo prodotto:
File Dimensione Formato  
polymers-14-03878-v2 (3).pdf

accesso aperto

Descrizione: Articolo
Tipologia: Versione editoriale
Licenza: Creative commons
Dimensione 966.5 kB
Formato Adobe PDF
966.5 kB Adobe PDF Visualizza/Apri

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11587/484085
Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 4
  • ???jsp.display-item.citation.isi??? 3
social impact